9-24
User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration
Obtain NW User Property
Set the required information to obtain the network user property from the LDAP server. The user name and E-
mail address obtained with this setting is shown in the user information, the status confirmation screen, and the
header of
E-mail.
1
Display the screen.
1 [Home] key > [...] > [System Menu] > [Job Accounting/Authentication]
2 Select " User Login Setting" [Obtain NW User Property].
2
Configure the settings.
Select [On] for "Obtain NW User Property" and add information on each item
To obtain the network user property from the LDAP server, [Network Authentication] must be selected for
the authentication method in "Enabling User Login Administration". Select "On" for "LDAP" in "Protocol
Settings".
Enabling User Login Administration (page 9-3)
Protocol Settings (page 8-46)
If the User Authentication screen appears, log in with a user who has the privilege to configure this
setting. If you do not know your login User Name or Password, please contact your Administrator.
Item Descriptions
LDAP Server Information
Server Name
*1
*1 If using Active Directory of Windows, the server name may be the same as the server name entered in the network
authentication.
Enter the LDAP server name or the IP address (up to 64 characters). If a
server name is not entered, user information will be acquired from the
server set for Network Authentication.
Port Port number for LDAP server. The default port number is 389.
Acquisition of User Information
Name 1
*2
*2 If using Active Directory of Windows, display Name of Attribute may be used as "Name 1".
Enter the LDAP Attribute to obtain the user name to be displayed from the
LDAP server (up to 32 characters).
Name 2
*3
Enter the LDAP Attribute to obtain the user name to be displayed from the
LDAP server (up to 32 characters).
Email Address
*4
Enter the LDAP Attribute to obtain the E-mail address from the LDAP server
(up to 256 characters).
Authentic at Type
*5
Set the authentication method. Select [Simple] or [SASL]. After changing
the setting, restart the system or turn the power off and then on.
Search Timeout Set the amount of time to wait before time-out in seconds (from 5 to 255
seconds).
LDAP Security Select the type of encryption according to the type of security employed by
the LDAP server. The value is [Off], [SSL/TLS] or [STARTTLS].
To Next Page
Loading...
Need help?
General
Weight and Dimensions
