5-6
Operation on the Machine > Using a Custom Box
Using a Custom Box
Custom Box is a component box which you can create within the Document Box and store data for later retrieval. You
can create or delete a Custom Box, and manipulate data in various ways as described below:
Creating a New Custom Box
1
Display the screen.
Select the [Document Box] key.
2
Create a custom box.
1 Select [Add].
2 Enter the box name and select the [OK] key.
Creating a New Custom Box (page 5-6)
Storing Documents (page 5-8)
Printing Documents (page 5-9)
Editing Documents (page 5-10)
Deleting Documents (page 5-11)
The operation on Custom Box you perform from operation panel can also be made using Command Center RX.
Command Center RX User Guide
• To use Custom Box, an optional SSD must be installed in the machine.
• If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
The factory default login user name and login password are set as shown below.
ECOSYS P6035cdn ECOSYS P7040cdn
Login User Name: 3500 4000
Login Password: 3500 4000
• If user login administration is enabled, log in with administrator privileges to perform the following operations. They
cannot be performed with user privileges.
- Creating a box
- Deleting a box of which owner is another user.
If the default screen of the box is set to a Job Box, display the Custom Box screen.
[Document Box] key > [Back] key > [▲] [▼] key > [Custom Box] > [OK] key
Up to 32 characters can be entered.
For details on entering characters, refer to the following:
Character Entry Method (page 11-10)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
