2F8/2F9/2GA
1-2-6
3. Shake the new toner container at least 10
times as shown in the figure in order to dis-
tribute the toner evenly inside the container.
4. Carefully remove the protective seal (orange
colored).
Figure 1-2-5
5. Install the toner container into the printer.
6. Push on the PUSH HERE marks on the
toner container until the container clicks into
place.
7. Close the top cover.
Figure 1-2-6
8. Open the cap of the waste toner box.
9. Open the left side cover.
10. Insert the new waste toner box as shown in
the figure. When the box is set correctly, it
will snap into place.
11. Close the left side cover.
Figure 1-2-7
Toner container
Protective seal
(orange colored)
REMOVE THIS TAG
BEFORE ADDING TONER
Toner container
Left side cover
Cap
Waste toner box
To Next Page
Loading...
