What to do if my Kyocera ECOSYS FS-2100D Printer displays 'Cannot remove the memory while in use'?
This message appears when Remove Memory was selected while a USB memory was being used. The previous screen will be displayed again in 1 or 2 seconds.
How to fix faint or blurred printing on my Kyocera ECOSYS FS-2100D?
First, check the EcoPrint settings and turn it off on the operation panel if it is on. Ensure the paper type setting matches the paper you are using. You may also refresh the drum to restore printing quality and adjust the print density. If you're using damp paper, replace it with a newer, dryer paper. If the problem persists after these steps, call for service.
What to do if my Kyocera ECOSYS FS-2100D displays 'Cannot connect'?
Check the settings of the wireless network interface. This issue occurs when the printer cannot connect to the network with the optional wireless network interface kit.
What to do if my Kyocera ECOSYS FS-2100D Printer displays 'Cannot connect. Multiple access points are enabled'?
Multiple access points were detected with the optional wireless network interface kit. Check the settings of the wireless network interface.
What to do if my Kyocera Printer prints a status page but not jobs from the computer?
First, ensure both ends of the printer cable are securely connected. If the issue persists, try replacing the printer cable or interface cable. Also, the problem might be with a specific file or application. Try printing a different file or using another print command to check program files and application software. If it only happens with one file, review the printer driver settings for that application.
Why is my Kyocera ECOSYS FS-2100D Printer printing with a gray background?
Refresh the drum to restore the printing quality and adjust the print density.
What to do if my Kyocera ECOSYS FS-2100D displays 'Close rear cover'?
Close the rear cover of the printer.
What to do if my Kyocera ECOSYS FS-2100D Printer displays 'Close top cover'?
Close the printer top cover.
What to do if nothing lights up on the Kyocera ECOSYS FS-2100D Printer operation panel?
First, ensure the power cord is securely plugged into the power outlet. If it is, try unplugging it, waiting a minute, and then plugging it back in and turning the printer on. Also, make sure that you press the power switch.
What does 'Add paper in cassette' mean on my Kyocera Printer?
Supply paper according to the paper source displayed (paper cassettes, MP tray, or optional paper feeders).
To Next Page
General