2F8/2F9/2GA-1
1-2-15
1-2-6 Installing the network interface card (optional for 30/31 ppm printer [EUR/USA model] only)
<Procedure>
1. Turn off the printer and disconnect the
power cord and printer cable.
2. Open the right side cover.
3. Remove the one screw and then open the
inner cover.
Figure 1-2-19
4. Remove the two screws and then open the
option interface slot cover.
Figure 1-2-20
Right side cover
Inner cover
Screw
Screw
Screw
Option interface slot cover
To Next Page
Loading...
