Kyocera FS-2000D - Page 34

2F8/2F9/2GA
1-2-16
5. Connect the relay cable connector to the
network interface card connector.
6. Secure the relay cable to the clamp.
Figure 1-2-21
7. Install the network interface card to the
option interface slot.
8. Put the relay cable connector through the
hole.
9. Secure the network interface card by two
screws.
Figure 1-2-22
Network interface card
Relay cable
Connector
Clamp
Connector
Relay
cable
connector
Option interface slot
Hole
Screw
Screw
Network interface card