30
Setup
Setting the Colour Density
The printer panel provides an interface to adjust the density of the toner applied to the
media. This makes it possible to offset changes in density that may result due to varying
environmental conditions or aging of the toner or imaging unit.
Perform the following steps to adjust the colour density:
Begin by printing a Colour Calibration Page. To print a Colour
Calibration Page, proceed as follows:
1
(1)Press the MODE key on the printer panel.
(2)Press the + key repeatedly until the message display indicates
Colour Calibration.
Colour >
Calibration
(3)Press the key.
(4)Press the + key until the message display shows >Print
Calibration Page.
>Print Calibra-
tion Page
(5)Press the ENTER key. A question mark (?) will appear.
(6)Press the ENTER key again.
A Colour Calibration Page will be printed.
(2)
(3)
(4), (5)
(1)
To Next Page
Loading...
