Kyocera FS-5900C - Jam at D

78
Care and Maintenance
■ Jam at D
Safety Caution:
The fuser is hot. To avoid personal injury, turn off the printer and wait 10 minutes
(after opening the front cover) for the fuser to cool before touching it.
Note:
First check the exit opening for media that has jammed and folded like an accordion.
It is especially difficult to see if the media is transparency film.
1
A
(Printing face up)
(1) Open the front cover and the right side cover.
(2) Turn the fuser’s large green knob counterclockwise to release the
jammed media.
(3) Remove the jammed media from the right side of the printer.
Safety Caution:
The fuser is hot. To avoid personal injury, turn off the printer and wait 10 minutes for
the fuser to cool before touching it.
(4) Close the front cover and the right side cover.
(1)
(2)
(3)