Installing the Page Printer
35
Testing Extended Memory
1.
Check that the power switch is off, plug the power cord into the printer, and turn the power on.
2.
Wait for the printer's ON LINE/A4 indicator to light, then press and hold the
SHIFT
key followed by
the
ON LINE/STATUS
key briefly.
3.
If installation has been performed properly, a status page will be printed. Check the
Available
Memory Item
in the upper right. Information on the SIMM installed in slot is shown here.
There is no problem if total memory has increased. (The printer is shipped from the factory with
4096 KB [4 MB] of memory.)
To Next Page
Loading...
