5-7
Chapter 5 Troubleshooting
The image is smeared
Clean the charger wire
Open the printer’s side cover. Pull the green main charger wire cleaning knob slowly in and out a
few times. See Section 4.2.
Faint or blurred printing
Check the control panel.
If the Toner low TK-20 Clean printer message is displayed and the indicator is flashing,
install a new toner kit. See Section 4.2.
Set the print density from the control panel to a higher level than the current setting. See Section
2.12.
Try changing the paper thickness setting on the Mode Select Menu. See Section 2.3.
Check the Ecoprint setting.
See Section 2.10.
To Next Page
Loading...
