Kyocera FS-C5015N - Making Default Settings

Using the Operator Panel
ADVANCED OPERATION GUIDE 2-37
Making Default Settings
Using the operator panel, you can set the default for the following items.
Default Emulation
You can change the emulation mode and character code set for the current
interface. The printer is capable of the following emulation modes:
• HP PCL 6 (HP Color LaserJet 8550)
• KPDL3 (compatible with PostScript 3)
The printer can automatically switch between HP PCL 6 and KPDL3
depending on the print job that is received from the computer. To do this,
select KPDL (AUTO) in the following procedure.
1
Press [MENU].
2
Press U or V repeatedly until Emulation > appears on the message
display. One of the emulation modes appears, indicating the emulation
currently in use.
PCL 6 (default)
KPDL
KPDL (AUTO)
3
To change the default emulation, press
[OK] ([ENTER]). A blinking question mark
(?) appears.
4
Press U or V repeatedly until the desired emulation mode is displayed.
5
Press [OK] ([ENTER]).
6
Press [MENU]. The display returns to Ready.
Printing KPDL Errors
The printer can print error descriptions when printing error occurs during
KPDL emulation. The default is Off — the printer does not print KPDL
errors.
1
Press [MENU].
2
Press U or V repeatedly until Emulation
> appears.
Emulation
?PCL 6
Emulation >
PCL 6