Using the Operator Panel
2-40 ADVANCED OPERATION GUIDE
6
Press [OK] ([ENTER]). A blinking question
mark (?) appears.
7
Select Regular or Dark using U or V.
8
Press [OK] ([ENTER]).
9
Press [MENU]. The display returns to Ready.
Changing the Default Font Size
You can change the size of the default font. If you selected a proportional
font, the character size can also be changed.
1
Press [MENU].
2
Press U or V repeatedly until Font >
appears.
3
Press Z. Press U or V until >Font
Select > appears.
4
Make sure that Internal is displayed and press Z.
5
Press U or V repeatedly until >>Size
appears.
6
Press [OK] ([ENTER]). A blinking cursor (_)
appears.
7
Press U or V to increase or decrease the value at the blinking cursor. The
font size can be set between 4 and 999.75 points, in 0.25-point increments.
Use Z or Y to move the cursor right and left.
8
When the desired size is displayed, press [OK] ([ENTER]).
9
Press [MENU]. The display returns to Ready.
>>Courier
? Regular
Font >
>Font Select >
Internal
>>Size
012.00 point(s)
>>Size
012.00
point(s)
To Next Page
Loading...
