Kyocera FS-C5015N - Page 99

Using the Operator Panel
ADVANCED OPERATION GUIDE 2-73
2
Press U or V repeatedly until Paper
Handling > appears.
3
Press Z.
4
Press U or V repeatedly until >Stack
Select appears.
5
To change the output stack, press [OK]
([ENTER]). A blinking question mark (?)
appears.
6
Press U or V select output stack - Top tray FaceDn or Rear tray
FaceUp.
7
When the desired output stack is displayed, press [OK] ([ENTER]).
Paper Handling >
>Stack Select
Top tray FaceDn
>Stack Select
?Top tray FaceDn