33
[HP-GL/2 Settings]
Pen Width Mode:
Grayscale Mode:
When “Values in file” is selected, the values of Pen Width and
Grayscale specified in the file are effective, respectively.
When “User defined values” is selected, the values of Pen Width
and Grayscale effect according to the following User setting,
respectively.
Pen Size:
When “User defined values” is selected, a value of Pen Size
specified by User is effective.
Grayscale:
When “User defined values” is selected, a value of Grayscale
specified by User is effective.
RTL Raster Density:
Adjust the density of HPGL RTL Image.
However, it is effective only if RTL image data are multi-valued
image.
Enable Clipping:
When this is checked, the value of HPGL PS command is taken as
the size of image.
When this is not checked, image size is taken from minimum to
maximum of image.
To Next Page
Loading...
