65
4.1.3. Remote Web Manager does not start up
The causes that Remote Web Manager does not start up is:
z Print Server is not started up
z Network between Print Server and client is physically down.
z Network between Print Server and client is logically down.
z Network configuration of Print Server is not properly set.
z Network configuration of client machine is not properly set.
As shown above. Check the following items.
(1) Check if network cable is connected properly. Confirm if network is
physically correct. Check if cables around hub and network support are
connected properly, and check the power source of them.
(2) Check if network service is proper. If those are connected properly, there is
a possibility that network service is not done properly. Remote Web
Manager is working on the web browser that is used TCP/IP protocol.
Confirm to the network manager if TCP/IP of client machine is properly set,
such as installation of TCP/IP service, IP address of client machine,
gateway or masking of sub-net.
(3) Confirm if Web browser is used at Internet Explorer 6.0 SP1.
Remote Web Manager is confirmed its operation using Internet Explorer
version 6.0 SP1 or later. When other browser than this is used, there is a
possibility that indication is not indicated properly.
To Next Page
Loading...
