Panel Setup
14 SETUP GUIDE
Default Gateway
1
In the IPv4 Setting menu, press U or V to select Default Gateway.
2
Press [OK]. The Default Gateway screen appears.
3
Use the arrow keys to set the default gateway.
Press U and V to increase or decrease, respectively, the value at the blinking
cursor. You can set any value between 000 and 255.
Use Y and Z to move the cursor right and left.
4
Press [OK]. The default gateway is stored and the IPv4 Setting menu reappears.
IPv6 Setting (TCP/IP IPv6 settings)
This selects the settings for TCP/IP (IPv6).
1
In the TCP/IP Setting menu, press U or V to select IPv6 Setting.
2
Press [OK]. The IPv6 Setting menu screen appears.
The options available in the TCP/IP (IPv6) settings are as follows:
• TCP/IP(IPv6) (Enable/disable TCP/IP (IPv6))
• Prefix Length (Prefix Length setting)
• RA(Stateless) (RA (Stateless) setting)
• DHCPv6 (DHCPv6 setting)
TCP/IP(IPv6)
1
In the IPv6 Setting menu, press U or V to select TCP/IP(IPv6).
2
Press [OK]. The TCP/IP(IPv6) screen appears.
3
Press U or V to select whether TCP/IP (IPv6) is enabled.
4
Press [OK]. The TCP/IP(IPv6) is set and the IPv6 Setting menu reappears.
Prefix Length
1
In the IPv6 Setting menu, press U or V to select Prefix Length.
2
Press [OK]. The Prefix Length screen appears.
3
Use the arrow keys to set the default gateway.
Press U or V to increase or decrease, respectively, the value at the blinking cursor.
You can set any value between 0 and 128.
Use Y and Z to move the cursor right and left.
4
Press [OK]. The Prefix Length is set and the IPv6 Setting menu reappears.
To Next Page
Loading...
Need help?
General
