Rigging procedures
Pole-mounting Syva
type of deployment pole-mount
rigging accessories Syva Pole
tools torque screwdriver
15 mm (5.9 in) screwdriver extension
T30 Torx bit
17 mm wrench
additional material 35 mm pole mount
min number of operators 1
Procedure
1. Remove the backplate from Syva and secure Syva Pole on Syva.
Store plates and unused screws in Syva Cov.
T30
T30
5 N.m
150 mm /
5.9 in
2. Mount the assembly on a pole.
3. Tighten the locking knob and the nut.
17 mm
23 Syva rigging manual (EN) version 1.1
To Next Page
Loading...
Need help?
General
