L.R. Baggs Active Di - Introduction; Getting Started

INTRODUCTION
Building upon decades of experience creating
studio-quality gear for the stage, the Align Active DI
i s the embodiment of LR Baggs engineering at its
highest level and uses the most pristine circuitry we have
developed in a DI. Our all-discrete design preserves the
authenticity of your sound while providing high head-
room for a wide range of signals. Equally at home on a
pedalboard or standalone, we are excited to oer a DI
with such a high degree of delity and functionality.
GETTING STARTED
1. Power the Active DI with a 9V power supply, 9V
battery, or 48V phantom power (a green light will
indicate phantom power is being used).
2. Plug your guitar into the input to activate the Active
DI (upper right hand side) and a cable into the ¼”
output (upper left hand side) and/or the or the XLR
output (on the back).
3. Plug the ¼” and/or XLR cable into your amp, PA, or
next pedal in the signal chain and experiment with
the DI.
4. Use the pad switch if necessary. Read section B in this
manual for setting your pad to the appropriate level.