L.R. Baggs Active Di User Manual

C. GROUND LIFT
Engage this switch to reduce or eliminate ground loop
related noise.
D. PHASE
Press this button to invert the phase. Usually, one phase
will provide better sound and feedback resistance. With
all acoustic instruments it is important to try both
phases each time you set up, because phase is relative
to your position on the stage.
E. MUTE
Press the footswitch to mute the signal (Note: the mute
will not aect the ¼” out when the Thru/Out switch is
set to thru). The red LED will light up when the Active DI
is muted. Press the footswitch again to un-mute
your signal.
F. THRU/OUT
When set to thru, the output completely bypasses all
circuitry and sends an unaected signal to the ¼” out.
When set to out, the signal will be aected by all the
controls. The XLR is not aected by this switch.
G. ¼” OUTPUT
The ¼” output is an unbalanced, line level output. You
can plug into any amp or device that has a ¼” input.
H. XLR OUTPUT
The DI out is a balanced XLR output for connecting to a
mixing board with an XLR (mic) cable.

L.R. Baggs Active Di Specifications

General

Brand	L.R. Baggs
Model	Active Di
Category	Music Pedal
Language	English