5 | Page
• The maximum wireless transmission range to the rain station is over 400 feet (121 meters) in
open air, not including walls or floors.
• Place your thermo-hygro sensor at least 6 feet off the ground.
• For accurate temperature readings your sensor needs to be shaded from the sun in a well
vented area.
• Mount your sensor vertically to allow moisture to drain out the bottom.
• Preferred location is on a north facing wall under an eave or deck rail.
• Avoid placing near a metal roof that will cause it to read high on sunny days.
• Avoid other sources of heat such as soffit vents, and window or door frames.
• For accurate humidity readings, avoid placement near vegetation and lakes or other bodies
of water when possible.
• Place your sensor in a well-vented area. Trapped moisture will cause inaccurate readings.
• Maximum transmission distance from your thermos-hygro sensor to your station, in open air
is 400 feet (121.92meters).
• Insert the mounting screw through the front of the transmitter and into the wall. Tighten the
screw to snug (do not over tighten).
WHERE TO I PLACE MY STATION?
Your station is designed for flexible placement on a desk or countertop, or to position on the
wall.
• Position within reach of an outlet that is always active. Some outlets in living rooms and in
bedrooms may only be active when the light switch is on.
• This station must operate with the 5 volt power cord in order to receive sensor updates
and/or to update Wi-Fi data when connected. Operation on battery power will only maintain
time/date settings if you need to move your station.
• Best reception occurs when only one wall is between your station and each sensor outside.
• Position you station six feet from other electronics and wireless devices. If you suspect RF
(radio frequency) interference, simply move your weather station a few feet.
WHAT IS DISTANCE | RESISTANCE | INTERFERENCE?
• The maximum transmitting range in open air is over 400 feet (121.92 meters) between each
sensor and your station.
• Consider the signal path from your station to each sensor as a straight line.
• Consider the distance the station is from other electronics in the home.
• Each obstacle: walls, windows, vegetation, stucco, concrete, and large metal objects will
reduce the effective signal range by about one-half.
• Mounting your sensors on a metal fence can significantly reduce the effective signal range.
To Next Page
Loading...
Need help?
General
