Lab.gruppen iP Series IP 1350 Brochure

iP 2100 iP 1350 iP 900 iP 450 iP 1150Q
Max output power
1)
Four channels
EIA at 1 kHz and 1 % THD
8 Ω per channel 425 W 300 W 200 W 110 W 130 W
4 Ω per channel 700 W 500 W 320 W 160 W 200 W
2 Ω per channel 1050W 700 W 470 W 200 W 270 W
8 Ω bridged 1400 W 1000 W 600 W 300 W 400 W
4 Ω bridged 2100 W 1400 W 900 W 400 W 540 W
Max output voltage
8 ohms load 58 V
rms
49 V
rms
39 V
rms
30 V
rms
32 V
rms
Peak voltage, no load 92 V 77 V 63 V 50 V 51 V
Distortion etc.
THD 20 Hz – 20 kHz
and 1 W to full power 0.05 % 0.03 % 0.02 % 0.05 % 0.05 %
THD at 1 kHz and 1 dB below clipping 0.005 % 0.005 % 0.005 % 0.03 % 0.01 %
DIM 30 at 3 dB below clipping 0.005 % 0.005 % 0.008 % 0.02% 0.008 %
Hum and noise < –105 dB < –110 dB < –105 dB < –105 dB < –105 dB
Channel separation at 10 kHz 70 dB 70 dB 70 dB 70 dB 70 dB
Output impedance 30 mΩ 30 mΩ 30 mΩ 30 mΩ 30 mΩ
Slew rate 45 V/µs 45 V/µs 30 V/µs 25 V/µs 30 V/µs
Inputs
Gain selectable 20, 23,26, 29, 20,23, 26,29 20, 23,26, 29, 20,23, 26,29 32
32, 35, 38, 41 32,35, 38, 41 32, 35,38, 41 32, 35, 38, 41
Impedance 20 kΩ 20 kΩ 20 kΩ 20 kΩ 20 kΩ
Common mode rejection 50 dB 50 dB 50 dB 50 dB 50 dB
Front panel
Gain controls 31 pos detent 31 pos detent 31 pos detent 31 pos detent 31 pos detent
Indicators per channel:
Protect Yes Yes Yes Yes Yes
C li p Ye s Ye s Ye s Ye s Ye s
Signal present – 40 dB – 40 dB – 40 dB – 25 dB – 40 dB
Rear panel
Input connectors Neutrik Combo+ Neutrik Combo+ Neutrik Combo+ Neutrik Combo+ Neutrik Combo
3 pin Phoenix 3 pin Phoenix 3 pin Phoenix 3 pin Phoenix
Clip limiters On/Off, each ch. On/Off, each ch. On/Off, each ch. On/Off, each ch. On/Off, each ch.
Power
Operation voltage, 230V/115V 130–260V/65–135V 130–260V/65–135V 130–260V/65–135V 130–260V/65–135V 130–260V/65–135V
Soft Start Yes Yes No No No
Peak inrush current 20 A 20 A 10 A 20 A 70 A
Full output power at 4 ohms,230V/115V 230V/115V 230V/115V 230V/115V 230V/115V 230V/115V
Minimum start-up voltage,230V/115V 190V/95V 190V/95V 180/95V NA 180/95V
230 V or 115 V versions Yes Yes Yes Yes Yes
Current draw at 4 Ω and 230V/115V
Idle,no load at output 0.8 A
rms
0.6 A
rms
0.5 A
rms
0.1 A
rms
0.6 A
rms
1/8 of full power (-9 dB) 5.2 A
rms
3.5 A
rms
2.3 A
rms
0.8 A
rms
2.9 A
rms
1/3 of full power (-5 dB) 8.0 A
rms
5.5 A
rms
3.7 A
rms
1.5 A
rms
4.5 A
rms
At full power (0 dB) at 1 kHz 1 % THD 13.0 A
rms
9.4 A
rms
6.5 A
rms
3.3 A
rms
7.9 A
rms
Dimensions
Width 483 mm (19") 483 mm (19") 483 mm (19") 483 mm (19") 483 mm (19")
Height 88 mm (3.5") 88 mm (3.5") 88 mm (3.5") 44 mm (1.75") 88 mm(3.5")
Depth 325 mm (12.8") 325 mm (12.8") 325 mm (12.8") 280 mm (11.0" 325 mm (12.8")
We i g h t 18.0 kg (39.6 lbs) 15.0 kg (33 lbs) 12.5 kg (27.5 lbs) 7.5 kg (17 lbs) 13.3 kg (29 lbs)
Approvals: CE
Emission: EN 55 103-1,E3
Immunity: EN 55 103-2, E3,with S/N below 1 % at normal operation level
Safety: EN 60 065, class 1, THX approval except iP 450
Technical Data.
7
1) Specifications measured with 230 V AC
Lab.gruppen reserve the right to alter functions or the specifications without prior notice.

Lab.gruppen iP Series IP 1350 Specifications

General

Brand	Lab.gruppen
Model	iP Series IP 1350
Category	Amplifier
Language	English