POWER AMPLIFIERS
iP 2100
KEY FEATURES:
2 x 425 watts
@
8
Ω
2 x 700 watts
@
4
Ω
2 x 1050 watts
@
2
Ω
(Measured just below clip level,
with both channels driven)
◆
Compact design:
2U high
◆
Intercooler
®
cooling
system with front-to-rear
airflow
◆
Multiple positions gain
switch
◆
Easily accessible dust filter
◆
Improved low-end power
bandwidth
◆
Neutrik Combo jack and
Phoenix terminal block
input connectors
◆
Bridged mono outputs
in one SpeakOn connector
The iP 2100 is a space-saving power amplifier, ideal for use in
installations as well as in cost-effective live sound systems.
The Iron Power (iP) family of power amplifiers is the new compact and
versatile line of professional power amplifiers with classic toroidal iron
transformers. To achieve a compact design, the latest semiconductor tech-
nology is utilized. This, together with Lab.gruppen’s proprietary copper
cooling system, Intercooler®, enhances the 2 ohms capacity.
A new Bi-phase wiring scheme also increases the capacity of the power
supply. This extends the power bandwidth in the low end.
Besides the traditionally superb Lab.gruppen sonic performance, there is a
full line of features to make the iP family functional in all situations from
installation to cost-effective live sound systems:
Multiple positions Gain switch
To meet the demands for a flexible gain structure in the system, Lab.gruppen
offers a multiple position gain switch. The maximum amplifier gain can be set
to all industry standards: 20, 23, 26, 29, 32, 35, 38 and 41 dB.
Versatile input connection
With the Neutrik Combo-jack we offer both the professional XLR-type
_standard and the semi-pro 1/4” TRS phono-jacks. For installations the 3-pin
Phoenix terminal block may be handier.
Soft Start
Toroidal transformers require a huge amount of start current to build up a
magnetic flux when the amplifier is switched on. Therefore Lab.gruppen have
included a soft start circuit to minimize the risk of blowing the wall fuse and
to reduce flickering in the lighting.
Sophisticated protection circuitry, combining:
– ALStm short circuit protection; the Adaptive Limiting System permits very
high peak currents, but keeps the amplifier within the Safe Operation Area.
– DC protection; protects against infrasonic signals
– VHF protection; protects the loudspeakers against strong very high
frequency non-musical signals above the audible range.
– Thermal protection; prevents the amplifier from being overheated. The
protection indicators on the front panel are switched on, as a warning, before
the protection process is initiated.
– AC protection; shuts down the power supply if the line voltage is outside the
operating voltage.
– Clip limiter; prevents severely clipped waveforms from reaching the
loudspeakers, whilst maintaining full peak power.
To Next Page
Need help?
General
