11
•
Enter the primary password
•
Enter the new service password, selecting a combination of 5 characters from the letters A-B-C-D.
•
You are prompted to repeat the new password, so enter again the previous combination.
•
Enter the primary password
•
If the password entered is correct, “PASSWORD OK” is displayed for one second and the system
returns to the PASSWORD MANAGEMENT section.
•
Press the OFF button (F1) to disable user password usage.
To return to the general programming menu, press the EXIT button twice
Access to the digital selector ET-DSEL as program selector now is free.
HOW TO CHANGE THE SERVICE PASSWORD
•
Select “SERVICE PASSWORD”
•
Press OK (F1).
Press the EXIT sbutton to return to the general programming menu.
If the password you entered does not match the previous one, the display shows PASSWORD ERROR, the system returns to the section
PASSWORD MANAGEMENT, and it is necessary to perform again the procedure.
ENABLING USER PASSWORD USAGE (primary and service password)
•
Select “PASSWORD ON / OFF”
•
Press OK (F1).
•
Press the ON
button to enable the usage of user passwords
and return to the menu PASSWORD MANAGEMENT.
To return to the work program view, press the EXIT
button twice.
From this moment on, whenever the user wants to access the digital selector ET-DSEL to change the automatic door work program, the
primary or service password must be entered.
When the user decides to enable password usage, it is recommended to change the combination of both primary
and service password.
DISABLING USER PASSWORD USAGE
•
From the PASSWORD MANAGEMENT section, select “PASSWORD ON / OFF”
•
Press the button OK (F1)
To Next Page
Loading...
