48
SOLVING PROBLEMS
Problems Raisons Solution
Machine does not work 1 - The cord is not plugged in
properly
2 - There is a problem with the
electrical current.
1 - Plug the device into an
appropriate outlet.
2 - Make sure all other electrical
devices are working normally.
If they are not working
correctly contact a technician.
Water temperature does not
increase
1.- Set temperature below or
close to the water
temperature
2.- Set heating time is too short
1.- Check the setting.
2.- Prolong the heating time.
Water goes on heating after the
set temperature is reached
1.- Program is wrong
2.- Temperature sensor is invalid
1 - Stop the programme and start
it again.
2 - Contact the technical service
for repair.
E01 appears on the display 1.- Machine does not be put into
water
2.- Water level is too low
1.- Put the machine into water
and push 2 times on / off
button
2.- Add water, make sure the
water level is between the
MIN and MAX line
The device is turned on but
nothing appears on the screen
1 - The device is not working
correctly.
1 - Contact the technical service
for repair.
The pump is noisy 1 - There is air in the pump
2 - The pump is dirty
1 - Shake the device after putting
water in it so the air in the
pump is released.
2 - Follow the cleaning
instructions to clean the
device.
To Next Page
Loading...
