35 Installation Manual 2014 - Riv 2
Installation Related
Y N Y N N/A
Adequate service space around the
outdoor unit
Isolating switches installed for heaters
Provision made for drainage of
outdoor unit
Dip switches set on PC board if either
thermostat or DHW
cylinder has been installed
Refrigeration Pipework
Insulated
Thermister installed in DHW cylinder in
top pocket of ASHP in lower pocket for
solar (Use heat conductive paste for
better heat transfer)
Mechanical Installation Y N
Refrigeration piping length (metres) Air removed from system
Additional Refrigeration Added (kgs) DHW Cylinder Un vented
System water Pressure (Bar) Flow and return isolation valves
installed
Operational Data Safe solenoid installed (solar thermal)
Outdoor unit Power Supply (vac) Installation compliant with G3 Regs
Outdoor Unit Current (Amps) A – Pressure/Temperature relief valve
installed
High Pressure Reading B – Combination valve installed
Low Pressure reading C – Tundish Installed
Booster heater power supply (vac) D – Expansion vessel installed
Booster heater current (Amps) E – Safety solenoid valve installed
∑TAcrossflowandreturnpipes(0C)
To Previous Page