Lampo IP66 LED - Advanced Mode (13 C d); Strobe Control

14
Advanced mode, 16bit colour resolution: 13C d
CHANNEL 1: GREEN, to control the light output of the green leds, from OFF to the Max Power.
DMX value function
0 Led OFF
From 1 to 254 Proportional Light output increase
255 Led at max power
CHANNEL 2: GREEN fine
, 16bit regulation of green leds
DMX value function
From 0 to 255 16bit regulation
CHANNEL 3: RED, to control the light output of the red leds, from OFF to the Max Power.
DMX value function
0 Led OFF
From 1 to 254 Proportional Light output increase
255 Led at max power
CHANNEL 4: RED fine
, 16bit regulation of red leds
DMX value function
From 0 to 255 16bit regulation
CHANNEL 5: BLUE
, to control the light output of the blue leds, from OFF to the Max Power.
DMX value function
0 Led OFF
From 1 to 254 Proportional Light output increase
255 Led at max power
CHANNEL 6: BLUE fine
, 16bit regulation of blue leds
DMX value function
From 0 to 255 16bit regulation
CHANNEL 7: AMBER
, to control the light output of the amber leds, from OFF to the Max Power.
DMX value function
0 Led OFF
From 1 to 254 Proportional Light output increase
255 Led at max power
CHANNEL 8: AMBER fine
, 16bit regulation of amber leds
DMX value function
From 0 to 255 16bit regulation
CHANNEL 9: STROBE
This channel sets the parameters of the strobe effect.
On the following table you have the dmx values, the strobe frequency (flash speed) and the strobe hold.
DMX value
Strobe frequency
(Seconds)
Strobe light hold
(Seconds)
DMX value
Strobe frequency
(Seconds)
Strobe light hold
(Seconds)
Da 0 a 9 0.00 0.00 34 0,32 0,07
10 2,00 0,16 35 0,30 0,06
11 1,88 0,16 36 0,28 0,06
12 1,76 0,16 37 0,26 0,06
13 1,64 0,15 38 0,24 0,06
14 1,52 0,15 40 0,20 0,05