42
7 Technical Data
DANGER!
Danger by electrical shock!
Shut BT300 down before opening the cover, otherwise it is possible to get in contact with con-
ducting parts. This may cause an electrical shock. Only open BT300 when it is disconnected
it all-pole.
Disconnect BurnerTronic all-pole.
NOTICE
Damaging the 0,8 Nm actuator by opening the actuator.
Do not open the actuator at another part as the cover of the electric connection, otherwise the
actuator will be damaged.
The warranty expires and is invalid.
Do not open the actuator but at the cover of the electric connection.
NOTICE
The limits of the technical data must be strictly adhered to.
Bursting strength Peak voltage 4 kV
Repeat frequency 2,5 kHz
Electrical safety Protection class 2 as per DIN EN 60730
Environmental conditions
To Next Page
