S A F E T Y PAGE 2
Last printed 1/31/2012 4:04:00 PM
Version Rev. 2003D-0
WARNING:
The following procedures and guidelines must be followed precisely to avoid
problems that can result in property damage, personal injury, or death. If you
have any questions related to this information.
The Model LT-30 Vacuum Tumbler must be installed with a minimum of 12-in. of
horizontal clearance from any part of other machinery, building walls, etc. It is the
owner’s responsibility to insure that the Model LT-30 Vacuum Tumbler installation
conforms to all local, state, and national codes and regulations.
For safe operation, the vacuum tumbler must be kept clean. A thorough weekly cleaning
schedule is recommended with a basic daily cleanup procedure. See the MAINTENANCE
Section for additional details on cleaning your vacuum tumbler.
Should you notice any unusual changes to your normal tumble schedule or the
operation of the vacuum tumbler, turn off the power and immediately investigate the
problem. Never operate the vacuum tumbler under suspect conditions.
Never make any additions or changes to the Model LT-30 Vacuum Tumbler. This will
void the warranty and could adversely affect the safety or operation of your vacuum
tumbler.
DO NOT attempt to operate your Model LT-30 Vacuum Tumbler without reading and
understanding this entire owner’s manual.
To Next Page
Loading...