M A I N T E N A N C E PAGE 17
Last printed 1/31/2012 4:04:00 PM
Version Rev. 2003D-0
Cleaning Vacuum Hose
To clean food particles from the vacuum hose, remove glass jar (located inside cabinet)
from the filter, and flush water through hose. Clean glass jar before replacing.
Emergency Stop Photo-Eyes
These are installed for your protection! When the sensor beam is broken, the machine is
automatically shut off. If the machine does not start, it is possible either the reflector or
the sensor eye is dirty or wet. If you do have a problem with the sensor, it is quickly
identified by the red light located on the back of the sensor. Check for power to the
photo-eye through the observation window. (The red light should be lit. If it is not lit,
wipe the photo-eye face and reflector to remove moisture.)
Maintenance
DISCONNECT POWER BEFORE SERVICING.
NOTE: Lock and tag power disconnect to prevent application of power.
Properly selected and installed electric motors are capable of operating for long periods
with minimal maintenance. Periodically clean dirt accumulations from open-type motors,
especially in and around vent openings, preferably by vacuuming (avoid imbedding dirt
in windings). At the same time check that electrical connections are tight.
Cleaning
Properly selected and installed electric motors are capable of operating for long periods
with minimal maintenance. Periodically clean dirt accumulations from open-type motors,
especially in and around vent openings, preferably by vacuuming (avoid imbedding dirt
in windings). At the same time check that electrical connections are tight.
To Next Page
Loading...