S T A R T U P PAGE 5
Last printed 1/31/2012 4:04:00 PM
Version Rev. 2003D-01
Installation
Unpacking
1. Carefully remove the crate from the skid.
2. Remove the machine from the skid.
3. Wipe down outside of the machine and drum.
4. Clean inside of the drum.
Checking Control Panel
1. Plug the power cord into 115-volt receptacle with a 15 Amp circuit breaker.
2. Press the (RST/ENT) button on the tumbler timer.
3. Check the photo-eye for power. (The red light on the back of the photo-eye should
be on. This can be seen through the observation windows near each photo-eye. The
light on the photo-eye must be on. If it is not on, wipe the face of the photo-eye and
the reflector opposite them to remove all moisture. If still not on, see instructions for
checking aim of the photo-eyes.)
Check Vacuum Pump Control
1. Turn on the vacuum pump. It should run.
To Next Page
Loading...