Land Solonet - Removal from a DIN Rail

User Guide User Guide
Page 35PP307 Page 35PP307
8.2 Removal from a DIN Rail
307029
Fig. 29 - Removing a SN-W/E Interface Unit from a Standard DIN Rail
Screwdriver
Use Screwdriver to
Unclip the Sliding
Spring Catch
• Insert a flatblade screwdriver into the sliding spring catch, via the slot
on the underside of the unit (see Fig. 29).
• Lever the sliding spring catch downwards so that it disengages from
the DIN rail.
• Lift the interface unit from the DIN rail.
8.2 Removal from a DIN Rail
307029
Fig. 29 - Removing a SN-W/E Interface Unit from a Standard DIN Rail
Screwdriver
Use Screwdriver to
Unclip the Sliding
Spring Catch
• Insert a flatblade screwdriver into the sliding spring catch, via the slot
on the underside of the unit (see Fig. 29).
• Lever the sliding spring catch downwards so that it disengages from
the DIN rail.
• Lift the interface unit from the DIN rail.