8.913-910.0 • LANDA PG • Rev. 11/11B
9
PRESSURE WASHER
OPERATOR’S MANUAL
OPERATION INSTRUCTIONS
STEP 3: Move the fuel valve lever
to the ON position.
To start a cold engine, move the
choke lever to the CLOSED position.
To restart a warm engine, leave the
choke lever in the OPEN position.
STEP 4: Open spray gun before
pulling the starter grip.
STEP 5: To start the engine pull
the starter grip lightly until you feel
resistance, then pull briskly. Return
the starter grip gently.
CAUTION: Pull trigger on spray
gun to relieve pressure if machine
does not start after one pull of
starter grip.
CAUTION: Small engines may
kick back. Do not hold starter grip
tightly in hand.
STEP 6: On models with electric
start: Turn the key to the START
position and hold it there until the
engine starts. If the engine fails to
start within 5 seconds, release the
key and wait at least 10 seconds
before operating the starter again.
NOTICE: Using the electric starter
for more than 5 seconds at a time
will overheat the starter motor and
can damage it. When the engine
starts, release the key, allowing it to
return to the ON position.
STEP 2: Read engine manual warn-
ing and operating instructions.
Pull wand coupler collar back and
insert pressure nozzle into coupler
then secure by pushing collar for-
ward to lock.
STEP 1: Turn on water at faucet
and squeeze spray gun trigger al-
lowing water to fl ow until a steady
stream comes out of wand. Then
install nozzle
Fuel Lever
Choke Lever
LI
VOR IN
BEDIENUN
NO UTILIZAR SI
Engine
Key
To Next Page
Loading...
