Lantronix EDS1100 - Page 124

5: Commands and Levels
EDS1100/2100 Command Reference 124
show history
Displays the last 20 commands entered during the current CLI
session.
show statistics
Shows ICMP statistics
state disable
Prevents ICMP packets from being sent or received.
state enable
Allows ICMP packets to be sent and received.
write
Stores the current configuration in permanent memory.
if 1 (config-if:eth0) level commands
bootp disable
Disables BOOTP.
bootp enable
Enables BOOTP.
clrscrn
Clears the screen.
default gateway <ip address>
Sets the configurable gateway IP address to the default value.
default mtu
Restores the default Maximum Transmission Unit (MTU) size.
dhcp client id binary <binary>
Sets the client id allowing binary characters.
Within [] use binary decimal up to 255 or hex up to 0xFF.
dhcp client id set <text>
Sets the client id in text format.
dhcp disable
Disables DHCP.
dhcp enable
Enables DHCP.
dhcp renew
Force DHCP to renew
domain <text>
Sets the domain name.
<text> = name of the domain.
exit
Exits to the config level.
hostname <text>
Sets the host name.
<text> = name of the host.
ip address <ip address/cidr>
Sets the IP address and network mask.
Formats accepted:
192.168.1.1 (default mask)
192.168.1.1/24 (CIDR)
"192.168.1.1 255.255.255.0" (explicit mask)
link
Enter link configuration level
mtu <bytes>
Sets the Maximum Transmission Unit (MTU) size.
no default gateway
Clears the default gateway.
no dhcp client id
Clears the DHCP client ID.
no domain
Clears the domain name.
no hostname
Clears the host name.
no ip address
Clears the IP address.
no primary dns
Clears the name of the primary DNS server.
no secondary dns
Clears the name of the secondary DNS server.
primary dns <ip address>
Sets the IP address of the primary DNS server.
secondary dns <ip address>
Sets the IP address of the secondary DNS server.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show status
Show interface status
write
Stores the current configuration in permanent memory.
ip (config-ip) level commands