Lantronix EDS1100 - Page 125

5: Commands and Levels
EDS1100/2100 Command Reference 125
auto show statistics
Continuously shows IP statistics
clear counters
Zeros counters
clrscrn
Clears the screen.
default ip time to live
Restores the default IP time to live.
default multicast time to live
Restores the default IP multicast time to live, which is one hop.
exit
Exits to the configuration level.
ip time to live <hops>
Sets the IP time to live, known by SNMP as "ipDefaultTTL".
<hops> = number of hops that a typical IP packet is allowed to live.
multicast time to live <hops>
Sets the IP multicast time to live.
<hops> = number of hops that a multicast IP packet is allowed to
live.
no clear counters
Unzeros IP counters
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show statistics
Shows IP statistics
write
Stores the current configuration in permanent memory.
ip filter (config-filter) level commands
add <ip address> <subnet mask>
Adds an entry to the IP filter table.
clrscrn
Clears the screen.
exit
Returns to the config level.
no filtering
Removes filtering so ALL addresses are allowed.
remove <ip address> <subnet mask>
Removes an entry from the IP filter table.
show
Displays the IP filter table.
show history
Displays the last 20 commands entered during the current CLI
session.
write
Stores the current configuration in permanent memory.
line 1 (line:1) level commands
auto show statistics
Continuously displays line statistics.
baud rate <bits per second>
Sets the line speed.
<bits per second> = the speed.
Standard speeds include 1200, 2400, 4800, 9600, 19200, and so
on.
clear line counters
Sets the serial counters to zero.
clrscrn
Clears the screen.
command mode always
Sets the current line to always be in command mode.
command mode echo serial string
disable
Disables user-defined serial boot string to be echoed in the CLI.
command mode echo serial string
enable
Enables user-defined serial boot string to be echoed in the CLI.
command mode serial string
Enables user to enter a custom string at boot time to enter
command mode.
command mode serial string <string>
Sets a string that can be entered at boot time to enter command
mode.
<string> = text.
command mode serial string binary
Sets a binary string that can be entered at boot time to enter