Lantronix EDS1100 - Page 132

5: Commands and Levels
EDS1100/2100 Command Reference 132
to
DOS-style line endings. If characters are already in DOS line-
ending order,
they are not converted.
eoj disable
Disables sending the end-of-job string after each print job.
eoj enable
Enables sending the end-of-job string after each print job.
eoj text binary <binary>
Sets the end-of-job text allowing for binary characters.
<binary> = string in binary format that will be sent to the printer at
the
end of each print job.
Within [] use binary decimal up to 255 or hex up to 0xFF.
eoj text set <text>
Sets the end-of-job text.
<text> = ascii string that will be sent to the printer at the end of
each
print job.
exit
Exits to the configuration level.
formfeed disable
Disables the printer from advancing to the next page at the end of
each
print job.
formfeed enable
Forces the printer to advance to the next page at the end of each
print job.
kill
Ends the current print job on this lpd line.
line <line>
Enters the line level.
<line> = number of the line (serial port) to be configured.
lpd <line>
Enters the configure lpd level.
<line> = number of the line (lpd serial port) to be configured.
no eoj text
Removes the end-of-job string.
no queue name
Removes the queue name.
no soj text
Removes the start-of-job string.
ppp <line>
Enters the serial line PPP level.
queue name <text>
Sets the name of the queue that this lpd line belongs to.
<text> = name for the queue.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show statistics
Displays statistics and status information for this lpd line.
soj disable
Disables sending the start-of-job string after each print job.
soj enable
Enables sending the start-of-job string after each print job.
soj text binary <binary>
Sets the start-of-job text allowing for binary characters.
<binary> = string in binary format that will be sent to the printer at
the
beginning of each print job.
Within [] use binary decimal up to 255 or hex up to 0xFF.
soj text set <text>
Sets the start-of-job text.
<text> = ascii string that will be sent to the printer at the beginning
of
each print job.
terminal <line>
Enters the configure-terminal level.
<line> = number of the terminal line (serial port) to be configured.