Lantronix EDS1100 - Page 133

5: Commands and Levels
EDS1100/2100 Command Reference 133
terminal network
Enters the configure-terminal level for the network.
test print <number of lines>
Prints lines of text directly to the lpd line.
<number of lines> = number of lines to print.
tunnel <line>
Enters the tunnel level.
<line> = number of the tunnel line (serial port) to be configured.
write
Stores the current configuration in permanent memory.
lpd 2 (config-lpd:2) level commands
banner disable
Disables printing banner for all print jobs. Only print the banner
when a
job requests it.
banner enable
Enables printing banner for all print jobs.
binary disable
Treats print job as ascii text. Filters out all non-ascii characters and
certain control characters.
binary enable
Treats print job as binary. Sends data byte-for-byte to the printer.
capture disable
Redirects serial output back to the line.
capture enable
Redirects serial output from the line to this CLI session.
clrscrn
Clears the screen.
convert newline disable
Disables converting single new line and carriage return characters
to
DOS-style line endings.
convert newline enable
Enables converting single new line and carriage return characters
to
DOS-style line endings. If characters are already in DOS line-
ending order,
they are not converted.
eoj disable
Disables sending the end-of-job string after each print job.
eoj enable
Enables sending the end-of-job string after each print job.
eoj text binary <binary>
Sets the end-of-job text allowing for binary characters.
<binary> = string in binary format that will be sent to the printer at
the
end of each print job.
Within [] use binary decimal up to 255 or hex up to 0xFF.
eoj text set <text>
Sets the end-of-job text.
<text> = ascii string that will be sent to the printer at the end of
each
print job.
exit
Exits to the configuration level.
formfeed disable
Disables the printer from advancing to the next page at the end of
each
print job.
formfeed enable
Forces the printer to advance to the next page at the end of each
print job.
kill
Ends the current print job on this lpd line.
line <line>
Enters the line level.
<line> = number of the line (serial port) to be configured.
lpd <line>
Enters the configure lpd level.
<line> = number of the line (lpd serial port) to be configured.
no eoj text
Removes the end-of-job string.