MPS/LPS User Guide 2: Installation
2-3
5.
Allow 45 seconds for the unit to fully boot. The LINK LED will
be lit if there is a valid network connection. The ACT LED gives
information about what the MPS is doing; for example, when
code is being downloaded as the unit boots, the LED will blink
green quickly. If you have connected a 100BASE-T cable
(MPS100 only), The Link and 100MBit LEDs should both be
solid green. If not, check your network connection.
6. Print a Test page by pressing the Test/Reset button.
Note: If the Power LED does not light or the Test page does not
print, refer to Appendix B:Troubleshooting.
To Next Page
Loading...
