Lantronix SISPM1040 L3 Series - Web User Interface; Initial Configuration

Lantronix SISPM1040-xxxx-L3 Install Guide
33855 Rev. A https://www.lantronix.com/ 13
Reset Button
By pressing the Reset button for certain period of time, you can perform these tasks:
Reset the switch: To reboot and get the switch back to the previous configuration settings saved.
Restore the switch to Factory Defaults: To restore the switch back to its original factory default settings.
Note: Based on the table below, users can easily judge which task is being performed by reading the LED
behaviors while pressing the Reset button. When the LED behaviors are correctly displayed, just release the
button.
Task to Perform Press Button for
SYS LED Port Status LED
Behavior Behavior
Reset the Switch 2 ~ 7 seconds
Blinking
All LEDs Light OFF
Green
Restore to Defaults 7 ~ 12 seconds
Blinking
All LEDs Stay ON
Green
Back Panel