UDS1100 Device Server User Guide 23
5: Configuration Using Web-Manager
You must configure the unit so it can communicate on a network with your serial
device. For example, you must set the way the unit will respond to serial and
network traffic, how it will handle serial packets, and when to start or close a
connection.
The unit’s configuration is stored in nonvolatile memory and is retained without
power. You can change the configuration at any time. The unit performs a reset
after you change and store the configuration.
In this chapter, we describe how to configure the UDS1100 using Web-Manager,
Lantronix’s browser-based configuration tool. (For information on using Setup
Mode, our command line configuration interface, see
6: Configuration via Telnet
or Serial Port (Setup Mode).
Note: The examples in this section show a typical device. Your device may have
different configuration options.
Accessing UDS1100 Using DeviceInstaller
Note:
For more information on DeviceInstaller, see Using DeviceInstaller.
1. Run DeviceInstaller and search for the list of available Lantronix device
servers.
2. Click on the UDS folder. The list of available UDS products display.
3. Expand the list of UDS1100s by clicking the + symbol next to the UDS1100
icon.
4. Select the UDS1100 unit by clicking its hardware address.
5. In the right pane, click the Web Configuration tab.
6. To view the UDS1100’s Web-Manager in the current DeviceInstaller window,
click the Go button. To open the Web-Manager in a web browser, click the
External Browser button.
Note: Alternatively, to open Web-Manager, open your web browser and
enter the IP address of the UDS1100.
A dialog box appears to prompt for a User Name and Password.
To Next Page
Loading...
