8: Setup Mode: Advanced Settings
TCP Re-Transmission Timeout
The TCP Re-Transmission Timeout is the interval to wait for acknowledgement of
transmitted TCP segments before re-transmitting them. Enter between 500 and 4000
ms. The default is 500 ms.
TCP Re-transmission Timeout (500 - 4000) (ms): (500) ?
Enable alternate MAC
If necessary, enable the alternate MAC address (if specified in the OEM setup
record).
Enable alternate MAC (N) ? _
Ethernet Connection Type
The xPico allows for the Ethernet speed and duplex to be manually configured. Enter
0 for auto-negotiation (default). To select the speed and duplex, enter one of the
following: 2 (10 MB/half duplex), 3 (10 MB/full duplex), 4 (100 MB/half duplex), or 5
(100 MB/full duplex).
Ethernet connection type: (0) ? _
Security Settings (Option 6)
Note: You can change security settings by means of Telnet or serial connections
only, not on the Web-Manager. We recommend that you set security over the
dedicated network or over the serial setup to prevent eavesdropping.
CAUTION
: Disabling both Telnet Setup and Port 77FE will prevent users
from accessing the setup menu from the network. Disabling Port 77FE
also disables the Web from configuring the device.
Select 7 to configure security settings.
Figure 8-2. Security Settings
Disable SNMP (N) ?
SNMP Community Name (public):
Disable Telnet Setup (N) ?
Disable TFTP Firmware Update (N) ?
Disable Port 77FEh (N) ?
Disable Web Server (N) ?
Disable Web Setup (N) ?
Disable ECHO ports (Y) ?
Enable Encryption (N) ?
Enable Enhanced Password (N) ?
xPico User Guide 56
To Next Page
Loading...
Need help?
General
