Rechargeable battery option
The optional NiMH rechargeable battery kit is an environmentally friendly
and economical alternative to alkaline batteries. NiMH batteries can be
charged up to 500 times under optimum conditions and contain no
hazardous materials.
To use the NiMH batteries, install
a set into the laser and charge
them fully prior to initial use (12
hours).
DO NOT PLUG THE CHARGER
INTO THE LASER UNLESS
NIMH RECHARGEABLE BAT-
TERIES ARE INSTALLED!
It is recommended that new NiMH
batteries be conditioned by
charging them fully, and running
them until fully discharged for two or three cycles. After that, the batteries
may be charged before they are fully discharged without running into
“memory” problems. A fully charged set of NiMH batteries should provide
about 65 hours of run time.
Note: Do Not Charge Alkaline or Carbon batteries. To do so could
cause them to rupture and damage your instrument.
If the laser is to be run while connected to the charger, the rechargeable
NiMH batteries must be installed. The laser may not function properly if
it is run off the charger when the NiMH batteries are not installed. The
laser should never be run off the charger when alkaline or carbon
batteries are installed.
Use only a factory prescribed charger with NiMH batteries. Use of a
non-authorized charger may result in danage to the batteries, or to the
laser’s electronics.
11
To Next Page
Loading...
