Case contents (will vary depending on package ordered)
Laser
Batteries
Receiver
Instruction packet
Battery installation
Pull on tab at base of door to remove.
Install 4 C-cell batteries (alkaline, or
NiMH rechargeable) according to
instructions molded on battery holder.
Carbon batteries are not recommended.
Replace battery door by hooking cover
into slots at the top of the housing and
pressing the tab closed. Do not plug
a charger into the laser unless NiMH
batteries are installed!
NiMH batteries should be fully charged
(about 12 hours) before first use.
To Next Page
Loading...
