Laser Technology TruPulse 200 - Tilt Sensor Functionality; Digital Processor Details; Section 3 - Basic Operations

Calibrate the Tilt Sensor (Models 360/B/R):
[1] Press-and-hold ( ), press until ( ).
[2] Press ( )( ), press ( )( ), press .
[3] ( ), hold in position 1, press ( ).
[4] Hold in position 2, press ( ).
[5] Hold in position 3, press ( ).
[Hang 360 R buttons over an edge and press .]
[6] Hold in position 4, press ( ).
[7] Hold in position 5, press ( ).
[8] Hold in position 6, press ( ).
[9] Hold in position 7, press ( ).
[10] Hold in position 8, press .
If ( ), press and repeat steps 3 through 10.
If ( ), press ( ).
[2]
[5]
Always perform on a at, fairly level surface. For the
TruPulse 360 R, you will need to use the edge of a
surface to access the buttons in position 3.
[1]
[3]
[8]
[7]
[6]
[4]