Why does my Laser Technology Measuring Instruments power off by itself?
Your Laser Technology Measuring Instruments might be powering off due to a few reasons. First, make sure the batteries are installed correctly. If they are, try replacing them. Also, the instrument automatically powers OFF if there is no activity for 15 minutes.
What to do if the in-scope red aiming dot is not visible on my Laser Technology Measuring Instruments?
If the red aiming dot isn't visible on your Laser Technology Measuring Instruments, try these steps: First, press the TRIGGER to activate the red dot. If it's still not visible, press the BRIGHTNESS CONTROL button to increase the intensity. You may also need to adjust the polarizing filter.
Why is my Laser Technology Measuring Instruments showing an E01 error code and no readings?
If your Laser Technology Measuring Instruments displays an E01 error code and isn't providing range or speed readings, try the following: First, test by measuring a wall approximately 50 feet (or 20 meters) away. Check the scope alignment. Restore the factory defaults. When measuring a short range to a small target, aim slightly above the target.
Why are my Laser Technology Measuring Instruments readings erroneous and not repeatable?
If you're getting erroneous or non-repeatable readings with your Laser Technology Measuring Instruments, consider these points: Ensure you have a clear line of sight. Check the scope alignment. If it's raining or foggy, make sure the weather filter is active; turn it ON if it isn't. When measuring a short range to a small target, aim slightly above the target.
Why is the range of my Laser Technology Measuring Instruments limited?
Several factors can limit the range of your Laser Technology Measuring Instruments. Ensure you have a clear line of sight. Keep in mind that rain or fog will reduce the unit’s maximum range. Is the Weather Filter active? If not, turn it ON. Also, acquiring a target through glass will reduce the unit’s maximum range. Make sure the lens is clean and check it for scratches.
How to fix no serial communication with Laser Technology Measuring Instruments?
To resolve the issue of no serial communication with your Laser Technology Measuring Instruments, verify the cable connection.
What to do if it's difficult to acquire a target while aiming through rain or snow with Laser Technology Measuring Instruments?
If you're finding it difficult to acquire a target through rain or snow with your Laser Technology Measuring Instruments, ensure the Weather Filter is active. Turn it ON if it is not.
Why is it difficult to acquire target while aiming through windshield with Laser Technology Measuring Instruments?
If you're having trouble acquiring a target through a windshield using your Laser Technology Measuring Instruments, ensure the Weather Filter is active; turn it ON if it isn't. If the windshield is bubble-shaped, try shooting through the center of it.
Information on instrument sounds, error codes, and radio frequency interference.
Step-by-step guide to performing a basic speed measurement.
Advice on choosing a location and understanding the cosine effect on speed readings.
Instructions for accurately measuring the speed of moving vehicles.
Guide on activating and using the weather filter for adverse conditions.
Steps to activate Survey Mode and take range measurements.
Details on performing Fixed and Delta Distance Tests for accuracy verification.
Addresses common problems like power loss, missing aiming dot, error codes, and inaccurate readings.
Solutions for limited range, aiming through windshields, and adverse weather conditions.
General| Brand | Laser Technology |
|---|---|
| Model | UltraLyte LR B |
| Category | Measuring Instruments |
| Language | English |
To Next Page
