Laser Technology UltraLyte LR B User Manual

Section #1 – Getting Started 18
Electronic Copy of LTI's UltraLyte LR B User's Manual - 2
nd
Edition © 2002
Figure 10. Aiming Dot Intensity Setting
Adjusting the Aiming Dot’s Intensity
The in-scope red aiming dot has eight intensity settings from OFF (00)
to
BRIGHT (07). Refer to the instructions and Figure 10 below to adjust
the red aiming dot’s intensity.
1. Press the BRIGHTNESS CONTROL button. The display
should look similar to Figure 10. The current setting is
whatever “br xx” is displayed. The factory default setting
is “br 05” as shown in the figure.
2. Press the BRIGHTNESS CONTROL button until the setting
is correct. It's easy to get the correct setting if you look
through the scope while making the adjustment.
3. Press the TRIGGER to return to the measurement mode that
was most recently active. Otherwise, press the button that
corresponds with whatever it is that you want to do next. For
more information, see Table 2 on Page 14.
• Each time you press the SCOPE BRIGHTNESS button,
the “br xx” value increases by 1.
• If you press the SCOPE BRIGHTNESS button while
“br 07” is displayed, you will see “br 00” next.
• Powering OFF the instrument does not change this
setting. The next time the instrument is powered ON,
the setting will be the same.

Laser Technology UltraLyte LR B Specifications

General

Brand	Laser Technology
Model	UltraLyte LR B
Category	Measuring Instruments
Language	English