Laser Technology TruPulse 200 User Manual

Overview of different measurement and target modes available on the TruPulse.

Instructions for checking the contents of the TruPulse package.

Explanation of how the laser sensor, tilt sensor, and digital processor work.

Details about the liquid crystal display and its indicators.

How the laser range sensor emits pulses to measure distance.

Information on how the TruPulse optimizes accuracy based on target quality.

How the integrated tilt sensor measures vertical angles and inclination.

Information on the proprietary ASIC chip for processing measurements.

Guide to installing AA or CRV3 batteries and understanding low battery indicators.

Explanation of the FIRE, UP, and DOWN buttons and their uses.

Methods to manually power off the device and auto-shutdown features.

Details on the various indicators shown in the LCD, like BATT, LASER, MULTI.

How to adjust the eyepiece and diopter for clear viewing.

Steps to verify all LCD indicators are functioning correctly.

Information on identifying and resolving error codes displayed on the unit.

How to display the main and auxiliary firmware revision numbers.

Instructions for attaching the neck strap to the TruPulse.

How to choose distance and inclination units for measurements.

Steps to enable or disable Bluetooth communication and its options.

Guide to re-aligning the tilt sensor after a drop or shock.

Step-by-step guide to taking distance measurements.

Important notes regarding measurement results and mode persistence.

Explanation of inclination measurement and percent slope calculation.

How to perform the three-shot routine to calculate target height.

Procedure for calculating missing line measurements between two points.

Operating and storage temperature ranges and environmental resistance.

Guidelines for protecting the unit from environmental factors and physical impact.

Recommendations for safe transport and storage of the device.

Instructions for cleaning the unit, including lenses and exterior surfaces.

Prerequisites for transferring data via RS232 cable and Bluetooth.

Details on the serial port connector and data format parameters.

Steps for downloading measurement data from the TruPulse.

How to use an external trigger for remote measurements.

Structure and content of various data download message formats.

Commands for controlling the TruPulse via serial interface.

Performance specifications for distance and inclination measurements.

List of available measurement and target modes.

Compliance statement regarding electromagnetic compatibility directives.

Physical characteristics, power requirements, and battery life.

Laser safety classification and environmental resistance standards (NEMA, IP).

Details on magnification, display type, and available measurement units.

What the warranty covers, period of coverage, and exclusions.

How warranty problems are corrected and relation to state law.

Solutions for when the unit does not power on or the LCD is blank.

Tips for resolving issues when the target cannot be acquired.

How to address the unit not turning off and measurement inaccuracies.

Guidance for troubleshooting specific error codes like E37.

How numbers and alphabetic characters are displayed on the LCD.

Explanations for various messages and abbreviations shown in the Main Display.