Laser Technology TruPulse 200 User Manual

Laser Technology, Inc. TruPulse 200 User's Manual 6
th
Edition
Page 38
Section 10 - Troubleshooting
**See page 17 for Bluetooth troubleshooting information.
Problem Remedy
The unit does not power ON or
the LCD does not illuminate.
Press
.
Check and if necessary, replace the battery or batteries.
The target cannot be acquired.
Make sure the unit is powered ON.
Make sure that nothing is obstructing the transmit and receive
lens.
Make sure the unit is held steady while pressing
.
Make sure that you press-and hold
as long as the laser is
active (10 second maximum).
Make sure that Filter (Flt) Target Mode is OFF if not using a
reflector.
The TruPulse does not have an
OFF button.
Simultaneously press-and-hold and for 4 seconds.
To conserve battery power, the TruPulse will turn itself off if
no button presses are detected after a specified length of time:
• Bluetooth OFF: 2 minutes
• Bluetooth ON: 30 minutes
Incorrect measurements.
Align the Tilt Sensor (page 18). If problem persists, contact
LTI for assistance. See inside front cover for LTI contact
information.
E37 (or similar value)
appears in the Main Display.
Contact LTI Service. See inside front cover for LTI contact
information.

Laser Technology TruPulse 200 Specifications

General

Brand	Laser Technology
Model	TruPulse 200
Category	Measuring Instruments
Language	English