Laser Technology TruPulse 200 - Section 9 - Specifications

Laser Technology, Inc. TruPulse 200 User's Manual 6
th
Edition
Page 34
Upload Serial Data Commands
 START_MEASUREMENT: GO = Single shot
(will output “E01” if no target found after 15 seconds)
 STOP_MEASUREMENT: ST
 SET_DISTANCE_UNITS: MU
Meters: 0
Yards: 1
Feet: 2
Note: Only International lasers include meters.
 SET_MEASUREMENT_MODE: MM
Horizontal Distance: 0
Vertical Distance: 1
Slope Distance: 2
Inclination: 3
Height: 4
Missing Line 6
 SET_TARGET_MODE: TM
Normal: 0
Continuous: 1
Closest: 2
Farthest: 3
Filter: 4
 GET_BATTERY_VOLTAGE: BV (millivolts)
Example Reply: 3125 = 3.125 volts
 SET_POWER _OFF PO
 Get ID $ID
response: $ID,TP200 MAIN,4.21,10-20-2015,103529
$PLTIT,RQ,ID
response: $ID,TP200 MAIN,4.21*09
 GET_INSTRUMENT_STATUS: TS,n
Battery Voltage OK: 0
Battery Voltage below Warning Level (2.15V) 2