Laser Technology TruPulse 200 User Manual

Laser Technology, Inc. TruPulse 200 User's Manual 6
th
Edition
Page 8
Buttons
The TruPulse has three buttons. With the TruPulse in your right hand and looking through the
eyepiece,
is located on top, near your index finger and and are located on the left side
of the instrument.
Measurem
ent Modes
Powers ON the unit.
Distance Measurement: fires the laser.
Inclination: Release “locks” tilt sensor in (1) Height
Measurement Mode and (2) Continuous Target Mode.
Height Routine
(HD) Fires the laser.
(INC) Release “locks” tilt sensor.
Target Modes
System Setup Modes
Selects option and returns to the Measurement Mode.
Aligning Tilt Sensor
When “DonE” message displayed, exits the routine and
returns to the Measurement Mode.

(UP)
Measurement Modes
Press to scroll to the previous Measurement Mode.
Press-and-hold 4 seconds to access the Target Mode.
Height Routine
Clears the last measurement and re-displays the previous
prompt.
Target Modes
System Setup Modes
Press to scroll to the previous option.

(DOWN)
Measurement Modes
Press to scroll to the next Measurement Mode.
Press-and-hold 4 seconds to access the System Setup
Modes.
Height Routine
Exits the Height Routine.
Target Modes
System Setup Modes
Press to scroll to the next option.
Powering OFF the TruPulse
To power OFF the unit, simultaneously press-and-hold and for 4 seconds. To conserve
battery power, the TruPulse powers itself OFF if no button presses are detected after a specified
length of time:
o Bluetooth OFF: 2 minutes
o
Bluetooth ON:
30 minutes

Laser Technology TruPulse 200 Specifications

General

Brand	Laser Technology
Model	TruPulse 200
Category	Measuring Instruments
Language	English