Laser Technology TruPulse 200 User Manual

Laser Technology, Inc. TruPulse 200 User's Manual 6
th
Edition
Page 6
Section 2 - Quick Start
Note: Only International lasers include meters.
1. Install the batteries (page 7).
2. Press
to power ON the TruPulse.
3. Select a target such as a tree or a building.
For this example, the target should be
approximately 250 feet (82 yards or 75 meters)
from y
ou.
4. Look through the eyepiece (see Figure #2) and
use the crosshair to aim to the target. The in-
scope LCD should look similar to Figure #3A.
o If the HD indicator is not displayed, press
or
until the HD indicator is displayed.
5. Press-and-hold
. The LASER status indicator is
displayed while the laser is active (Figure #3B). The
laser will remain active for a maximum of 10 seconds
while acquiring data about the target.
o If the target is not acquired, release
and repeat
this step.
6. Release
once the distance is displayed (Figure #3C).
The measurement will flash one time and then will be
displayed steady until you press a button or the unit
powers OFF.
o Press
or to scroll through the
measurement modes and see the results acquired
for each function.
o Repeat steps #3-#6 above to take another
measurement.
o Simultaneously press-and-hold
and
for 4 seconds to power OFF the T
ruPulse.
Figure #2
Figure #3

Laser Technology TruPulse 200 Specifications

General

Brand	Laser Technology
Model	TruPulse 200
Category	Measuring Instruments
Language	English